6.0 powerstroke crank no start hot

No Low Oil Pressure While Cranking On 60 Powerstroke. Today we get to work on the hated 60 liter Ford Powerstroke diesel.

Ford Diesel 6 0l 7 3l Troubleshoot Hard Or Won T Start Problems Can T Start Hot Cold Youtube

Discussion Starter 1 May 13 2014.

. This is what I found on this 60 hot crank no start would start once the engine closed down let me know if theres anything. A worn STC will NOT crank back up after it is shut down HOT unless you wait for a while for the oil to cool again thicken. Ford 60 No Crank No Start.

This is the start to gaining access to the top of the engine to remove the valve covers. I did have a 60 once that would not start because of a shorted out fuel injector. Here is my current situation.

At 210000 I had blown headgaskets and tore it down with cab off while in there here is a list of what was done. OHMed the two new sensors both read 400ohms. Hi All I have a 2007 F 350 Now that when It gets hot It will not start.

It has a new HPOP Fresh oil. I have a 2004 F250 60 with 165000 miles recently i had driven the truck all day with no issues or symptoms i stopped fro a few minutes come back out go to start it and it cranks but wont start i did get it to start about an hour later idle was perfectly normal take off down he road get it to about 55 MPH and it shuts off due to it being. 60 No Start No Sync Page 6 Ford Power Stroke Nation.

Discussion Starter 1 Apr 15 2010. Lets checked the FICM and high pressure. We had a different 60L in the shop that runs fine just in for service so we tested its oil pressure hot with the crank sensor disconnected and it only has 5 psi cranking.

DO NOT USE STARTING FLUID of any kind on that engine or any engine with glow plugs. 2005 60l - Crank Tries To Start No Sync Replaced Almost Everything - Ford Truck Enthusiasts Forums. 60L Power Stroke Engine and Drivetrain.

I have a 2006 F350 60 has 240000 km on it and now has a crank no start when hot. I can let it cool for a couple hours and it will crank and run until. So here is the story I maintain this truck religiously Ive owned since 160000km and have done oil changes every 5000km with rotella t6 and ford filter and.

Evidentley this is normal. Honestly ive never had a hot no start condition on a 60 that was caused by a camcrank sensor issue but thats just my experience. Low oil pressure gauge indicate a fault with oil pressure switch or oil pump.

Changed it out and the truck would not start at all. Hey guys need an experienced ford techs advice no idea where to start with this oneand pulling my hair out tard. I checked it with a scanner and it is not building high oil pressure when hot.

Plug in the crank sensor hits 9v and. Also check your engine oil level the injectors in that engine are operated by oil pressure. Joined Jan 4 2008 10 Posts.

Bought ANOTHER new one from Ford changed it out- same thing. While cranking oil pressure gauge on Instrument cluster should between low and high in few seconds after cranking. No oil pressure on instrument cluster can be several reasons.

Got towed in as a cranks but wont start vehicle. Leak on high pressure rail plug. 6 Jul 30 2011.

Possible way to get your 2005-07 powerstroke started again to get you out of a bind. Threw a code for a crankshaft position sensor. Severe engine damage can and will result from use of starting fluids in diesels with glow plugs.

Jump to Latest Follow 1 - 3 of 3 Posts. The STC fitting if worn will cause a long-crank or no-start condition when HOT which is often accompanied by poor performance when HOT. 2003 1102 Ford F-350 60 Powerstroke Truck had started running rough no power.

Oil pressure switch is bad. Now it cranks but no start. Bought a brand new one from Ford.

No oil no start. When the engine is cold it starts fine with no problem.

How To Diagnose And Repair The 6 0l Powerstroke Crank No Start